SpanishEnglish
Contact Us

Automatic Placket Fusing, Cutting and Stacking

Home > Apparel > Automation > 981
Share:
Automatic Placket Fusing, Cutting and Stacking - 981
981 Brochure

Best viewed using Firefox or Chrome


Automatic Placket Fusing, Cutting and Stacking - Model 981 - xtras --- atlatt.com

981_02

1981C-1000 Infeed Assembly with Slitter up to 10" Wide Placket



1981C-200 Placket Measure, Cut & Stack Unit




Model 981

Automatic Placket Fusing, Cutting and Stacking

  • Plackets may be individually cut or roll fed
  • Simple, easy to adjust placket attachment
  • Upper and lower heating elements for faster belt speed
  • Automatic cool-down cycle
  • Cutter automatically cuts plackets to correct length, counts, stacks, and discards waste
  • Modular design
  • Modules may be purchased separately
  • Use pre-slotted or plain interlining
  • Plain lining slit automatically
An adjustable, easy to load, placket attachment utilizing a fusing machine that has both top and bottom heating elements for faster belt speed, an automatic cutter, stacker, and counter.
    Technical Information:
Voltage (v/ph/hz)220v 1ph
Current (amps)25
Air pressure (psi)90
Air consumption (cfm)10
Shipping weight (lbs)800
Shipping dimensions (w/l/h, inch)72 x 62 x 60
981 Footprint
All modules may be purchased separately.
When using a roll feed placket, the operator loads a roll of fusing and a roll of placket material, presses the start button, and the machine continues to run until the material runs out or the desired number of plackets is reached.When using individually cut plackets, the operator loads a roll of fusing and hand loads the plackets.The fused plackets are automatically cut to the correct length, counted, stacked and the waste is discarded. The plackets are indexed to a holding tray when the desired quantity is reached for each stack. The automatic cutter/stacker requires no additional attention.
Approximately 1,410 individually fed plackets per hour.
Approximately 2,220 continuously fed plackets per hour.
(One operator can run two machines)

Depending on material and size of parts
  •  
Notice: Contents subject to change...[more]Change Notice:

All content contained herein is subject to change without notice. Atlanta Attachment Company reserves the right to make changes, modifications, additions, corrections or deletions. Atlanta Attachment Company may terminate, change, suspend or discontinue any product in this catalog, including the availability of any products, at any time. Every effort is made to keep products up-to-date but due to the nature of printed media, changes may only be available online or by contacting your sales representative.

All materials contained herein are additionally protected by United States copyright law and may not be used, disclosed, reproduced, distributed, published or sold without the express written consent of Atlanta Attachment, which consent may be withheld in Atlanta Attachment's sole discretion. You may not alter or remove any copyright, trademark or other notice from copies of these materials.

Atlanta Attachment Company, AAC, Atlanta Parts Depot, "Sudden Service", Sewing Automation, individually and when used in combination are registered trademarks of Atlanta Attachment Company.

© 2016 Atlanta Attachment Company. All rights reserved.
  • 362 Industrial Park Drive, Lawrenceville, GA 30046 USA
  • 770 963-7369 - FAX 770 963-7641
  • © 2016 Atlanta Attachment Company   |   Last updated Aug 2016